Switch Value Output of TFmini Plus v1.0
A10,Keshi Building, No.28, Xinxi Rd, Haidian district, Beijing, China. 100084 Page3
Please download "serial assistant sscom5.12.exe" to send commands to radar.
Open the SSCOM, the interface is as follows:
Fig.3 Serial assistant SSCOM
Select the port which the radar is connected, and check “Open Serial Port”, confirm the baud
rate is 115200. Then click the [Extension], and displayed as follows:
Fill in commands in this blank position (the commands refer to Chapter 4.3) and check HEX.
To Next Page
Loading...