Degree of Protection Against Ingress of Water And Particulates
Conform to the Waste Electrical and Electronic Equipment / the
Restriction of the Use of Certain Hazardous Substances in Electrical
and Electronic Equipment
High temperature warning
IP22
6. Device Operation
1.
Place the device on a steady flat table where the settings are easy to reach and the informa-
tion on the display can be clearly seen by the user. Maintain at least 5cm (2 inches) between
the device and the wall to ensure that the air inlet is not obstructed.
2.
When using the device, ensure the surrounding air flows freely and keep the device away
from any heating or cooling devices (air conditioning vents, radiators, etc.)
3. Place the air filter in the slot at the Air Inlet port.
4. Fill water into water tank: remove water tank from device (refer to picture ➀); open the
water tank and then pour pure water into it. Please pay attention that the water amount shall
not exceed the maximum water line (refer to picture ➁)
It is recommended to replace water from water tank every day.
When adding water to the water tank, do not exceed the maximum water line. Otherwise, it will
increase the risk of water ingress into breathing tube and the host.
5. Put the water tank back into device (refer to picture ➂);
6. Connect one end of breathing tubing into Air Outlet (refer to picture ➃).
Notice
7. Connect the mask into the other end of the tubing (refer to picture ➄);
8. Connect the power adapter into the Power Port on the rear of the device (refer to picture ➅)
37
To Next Page
Loading...