ASBER AEF-4050 S - User Manual

Questions and Answers

D
Dana BaileyAug 5, 2025
What to do if the pilot will not light on my ASBER AEF-4050 S?
- A
  Aaron MarquezAug 5, 2025
  If the pilot light on your ASBER Fryer won't ignite, start by ensuring the main gas valve is turned “ON”. Also, check that the gas tap dial is set to the “Pilot” position and is depressed while you attempt to light it.
A
Angela MoralesAug 9, 2025
What to do if the main burners will not ignite on my ASBER AEF-4050 S?
- K
  Karen HoltAug 9, 2025
  If the main burners on your ASBER Fryer fail to ignite, several factors could be responsible. First, ensure the pilot light is lit and check the gas pressure. Next, verify the thermopile is correctly installed in the pilot, pushing it in tightly, ensuring the pilot flame engulfs it. Also, confirm the gas tap dial is set to the “ON” position and the thermostat is set to the desired temperature. If these steps don't resolve the issue, the gas valve or hi-limit switch might be defective and need replacement.
S
sarahcurryAug 14, 2025
Why is my ASBER AEF-4050 S Fryer oil/shortening scorching and breaking down?
- A
  Abigail AllenAug 14, 2025
  Several reasons can cause oil/shortening to scorch and break down in your ASBER Fryer. Primarily, the operating temperature might be too high, or the thermostat could be out of calibration. Additionally, overused oil/shortening or infrequent filtering can contribute to this issue. To resolve this, relocate and secure the thermostat bulb at the proper position, re-calibrate the thermostat, or replace the oil/shortening, ensuring frequent filtering.
D
Daryl GillespieAug 17, 2025
How to fix an ASBER AEF-4050 S that does not heat up fast?
- S
  ssuttonAug 18, 2025
  If your ASBER Fryer is not heating up quickly, it could be due to several reasons. You may have insufficient gas, so ensure it is set at the proper temperature. Alternatively, the gas line might be clogged, requiring removal and cleaning. Overloading the fryer can also slow down the heating process, so try cooking smaller loads.
R
Robert VasquezAug 22, 2025
Why is the temperature on my ASBER AEF-4050 S not controlled?
- C
  carrmariaAug 22, 2025
  If you're experiencing issues with temperature control on your ASBER Fryer, it could be due to several factors. The thermostat bulb might be out of its proper position, or the thermostat itself may be out of calibration. Additionally, a defective thermostat or gas valve could be the cause. To address these issues, relocate and secure the thermostat bulb in the correct position, re-calibrate the thermostat, or consider replacing the thermostat or gas valve.
S
schmidtfrankAug 27, 2025
What to do if the pilot light will not stay lit on my ASBER Fryer?
- S
  Susan CollinsAug 27, 2025
  If the pilot light on your ASBER Fryer refuses to stay lit, there are a few potential causes. First, make sure you are depressing and holding the gas tap dial long enough after lighting the pilot. It's also possible that the thermopile is defective and needs replacement, or the pilot flame isn't properly adjusted, in which case you should adjust it with the pilot adjustment screw on the combination valve.
K
Kara GutierrezAug 30, 2025
What to do if my ASBER AEF-4050 S Fryer shuts off and I cannot re-light the pilot?
- L
  Linda AndersonAug 31, 2025
  If your ASBER Fryer shuts off and you're unable to relight the pilot, it could be due to a few reasons. The hi-limit may have cut off. Also, the thermostat could be defective or out of calibration. A defective hi-limit switch may also cause this issue.