33
S2 MAGNETIC SPINNING BIKE
SCREEN
3.9. Pause Press [Start/Enter] once during riding to enter pause mode.
The time bar displays ridden time or remaining time.
RPM and speed display zero.
Distance shows ridden distance.
Calorie displays burned calories or remaining goal calories.
Resistance can be adjusted but not with the console buttons.
The power bar displays zero.
3.10. Resume Press [Start/Enter] once in pause mode to resume riding.
All values return to real-time tracking.
3.11. End Long-press [Start/Enter] for three seconds to end the riding session.
The time bar shows the total ride time.
The distance bar displays total cumulative distance.
The calorie bar shows the total calories burned.
3.12. Reset Long-press [Reset/Return] for three seconds to reset the console.
Clear all data and return to the initial state.
3.13. Bluetooth
Connection
Long-press [Connect Bluetooth ® Heart rate] for three seconds to search for and
connect to nearby devices with Bluetooth.
The heart rate monitor starts flashing when connected.
Check the device and ensure proper setup if no signal is detected.
3.14. Discon-
nection
If speed and resistance signals fail to reach the console on time, a short, continu-
ous beep will sound.
An “E” fault code will appear on the screen.
Cut off the power and check the connections before restarting.
To Next Page
Loading...