© 2021 United States Stove Company
9
REPLACING THE GAS CYLINDER
device. The cylinder must have a connection device
compatible with the connection for the appliance.
The cylinder used must include a collar to protect
the cylinder valve. Never connect an unregulated
propane cylinder to the heater.
The knob on the LP tank must be closed. Make sure
that the knob is turned clockwise to a full stop. The
cylinder supply system must be arranged for vapor
withdrawal. Check that the control knob on the
control unit is turned off. Hold the regulator in one
hand and insert the nipple into the valve outlet. Be
sure the nipple is centered in the valve outlet. The
coupling nut connects to the large outside threads
on the valve outlet. Hand-tighten the coupling nut
clockwise until it comes to a full stop. Firmly tighten
by hand only.
To Disconnect: Fully close the tank valve by turning
until the regulator assembly detaches clockwise.
Turn the coupling nut counterclockwise.
• Do not store a spare LP-gas cylinder under or near
this appliance;
• Never ll the cylinder beyond 80 percent full;
• Place the dust cap on the cylinder valve outlet
whenever the cylinder is not in use. Only install
the type of dust cap on the cylinder valve that is
provided with the cylinder valve. Other type of
caps or plugs may result in leakage of propane.
WARNING:
to municipal requirements. Swallowed small
swallowed or inhaled. Keep children away
To Next Page
Loading...