© 2021 United States Stove Company
5
Secure the three propane tank brackets (MM) to
the base (G) using two M6 bolts (EE) and nuts (GG)
each. Note: Once assembly is complete use the
three provided M8*30 bolts (PP) to secure the gas
tank into posit.
MM
G
GG
EE
KK
PP
Attach each of the three anchor arms (HH) to the
base (G) using two M6 bolts (EE) and nuts (GG) each.
G
GG
EE
HH
Note: To secure the unit, please use three anchors
(LL) to nail the unit to the ground. For cement
ground or wood ground unsuitable for nails, please
use expansion screws (screws not included, may be
bought from local stores).
G
LL
1. Attach wheel assembly (I) to base (H). Line up
holes in wheel bracket with corresponding holes in
base, insert two bolts M8 x 16 (BB) through holes,
and nger tighten two M8 ange nuts (AA). Be sure
that the wheel assembly is parallel to the base, and
fully tighten bolts.
G
II
NN
H
HARDWARE USED
NN
II
Bolt M8 x 16
M8 Flange nut
x 2
STEP 1
1-1. Position the 3 tank housing supports on the
base as shown in the picture.
1-2. Use 3 bolts (M8 x 15 mm) to attach the tank
housing supports to the base.
F
ll*3
To Next Page
Loading...