27
Troubleshooting
Problems
Possible causes
Action
• The spray arms are not
rotating.
• Old dishwasher detergent.
NB! Detergent is a perishable.
• Incorrect dosage of deter-
gent.
• Incorrect program chosen.
• Incorrect loading of the
dishwasher.
• Glasses and cups have
tipped over during the wash.
• Dishwasher fitted with
water softener is leaking
salt.
• Incorrectly set water sof-
tener.
• Incorrectly set rinse aid
dispenser.
• The salt compartment is
empty.
• Phosphate-free detergent
in combination with hard
water.
• Too high a temperature
and/or too much detergent
can cause etching on (crys-
tal) glass. Unfortunately this
cannot be remedied, only
prevented!
• Too high dosage of rinse
aid.
The dishes are not clean.
Stains or a film on the
china.
• Lift off the arms and clean.
• Avoid large packs.
• Dispense according to the
level of water hardness.
• Select the option “HIGH
TEMP. ” or Change to a
more intensive program.
• Do not cover china with
large bowls or similar.
• Load the china securely.
• Check that the cover of the
salt compartment is properly
screwed on. Otherwise
phone forService.
• See the chapter on water
softeners.
• See the chapter on rinse
aid.
• Top up with salt.
• Change detergent.
• Wash (crystal) glass at a
low temperature and dis-
pense dishwasher detergent
with care. Contact the dish-
washer detergent manufac-
turer.
• Reduce dosage. See the
chapter on rinse aid. If the
water is very soft, you could
try diluting the rinse aid (1
part rinse aid, 1 part water).
The china has a whitish-
blue sticky film.
To Next Page
Loading...
Need help?
General
