EasyManua.ls Logo

Asko DBI344ID.W - User Manual

Asko DBI344ID.W
47 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Loading...
USER MANUAL
Dishwasher
EN
DBI344ID.W
DBI344ID.S
DBI344ID.B
DBI344ID.BS

Questions and Answers

  • R
    Ronald MartinAug 19, 2025
    Why won't my Asko DBI344ID.W start?
    • J
      Jose CortezAug 19, 2025
      Your Asko Dishwasher might not start because the door isn't properly closed; please, check it. Also, the door lock might not have clicked into place. In this case, open the door, press and hold until the display flashes, wait until it stops (60 seconds), and close the door again to ensure the lock clicks. If the Delayed start option is selected, press and hold for three seconds to cancel it. Check if the plug is correctly plugged into the wall socket and verify that a fuse/circuit breaker hasn't tripped. If the display doesn't show "Program started", press until it does. If you opened the dishwasher mid-cycle, simply close the door and wait for the program to resume.
  • J
    Jaime MorrisAug 21, 2025
    How to fix Asko DBI344ID.W not drying dishes enough?
    • M
      Michael ChenAug 21, 2025
      If your Asko Dishwasher isn't drying dishes adequately, ensure the Auto door open option is activated. Make sure you fully load the dishwasher. Check the rinse aid level and increase the dosage if needed. If you're using an all-in-one detergent, try switching brands or deactivate the TAB setting and use separate salt and rinse aid.
  • A
    ashley62Aug 23, 2025
    Why are my dishes not clean after using Asko Dishwasher?
    • S
      swansoncynthiaAug 23, 2025
      If your dishes aren't clean after using your Asko Dishwasher, start by checking that the spray arms aren't blocked by dishes and can rotate freely. Clean the spray arms if the holes or bearings are blocked. Ensure you're using a suitable dishwashing program, such as the Intensive program for very dirty dishes. Verify that you're using the correct detergent dosage for your water hardness and that your detergent isn't old. Also, make sure dishes are loaded correctly, filters are clean and properly fitted, and the drainage pump stop is in place.
  • K
    Kelsey NormanAug 26, 2025
    What to do if water remains in my Asko DBI344ID.W Dishwasher?
    • M
      Michael GriffinAug 26, 2025
      If water remains in your Asko Dishwasher after a cycle, begin by cleaning the coarse and fine filters. Ensure the filters are correctly fitted. Inspect and clean the drainage pump if there's debris. Verify the yellow drainage pump stop is in place. Check the drainage hose for kinks or blockages, ensuring it's properly connected to the sink unit's water trap with an inner diameter of at least 14 mm.
  • J
    Joseph RamseyAug 27, 2025
    What to do if my Asko Dishwasher leaves spots or films on the dishes?
    • S
      Sean LewisAug 28, 2025
      If your Asko Dishwasher leaves spots or films on the dishes, it could be due to several reasons. Check the rinse aid dosage setting. If you're using all-in-one detergent, consider switching brands or deactivating the TAB setting and adding salt and rinse aid separately. Ensure the salt compartment is full and the water softener setting is correct. Also, verify that the salt compartment lid is properly tightened. If you are washing crystal, use a low temperature and a small amount of detergent.
  • P
    Penny CampbellAug 30, 2025
    How to get rid of bad odour in Asko DBI344ID.W?
    • G
      Gabriella GlassAug 30, 2025
      To eliminate bad odors in your Asko Dishwasher, clean around the seals and corners with a washing-up brush and a low-foaming cleaner. If you frequently use low-temperature programs, run a high-temperature program once or twice a month, or use the self-cleaning program.
  • D
    Deanna RobinsonSep 1, 2025
    How to remove grease deposits in my Asko DBI344ID.W Dishwasher?
    • P
      Pamela SimpsonSep 1, 2025
      To remove grease deposits from your Asko Dishwasher, periodically select a high-temperature program like the Intensive program for very dirty dishes. Alternatively, run a self-cleaning program once or twice a month.
  • M
    melanieevansSep 3, 2025
    Why are there spots on stainless steel or silver after using my Asko DBI344ID.W?
    • J
      Jack HernandezSep 3, 2025
      Spots on stainless steel or silver after using your Asko Dishwasher can be caused by some foodstuffs, such as mustard, mayonnaise, lemon, vinegar, salt and dressings, if left for too long. Rinse off these types of foodstuffs if you're not starting the dishwasher immediately, and use the Rinse and hold program. Also, separate dishes made from different metals, such as silver, stainless steel, and aluminum, to avoid contact during dishwashing.
  • M
    Monica TaylorSep 5, 2025
    What to do if my Asko DBI344ID.W Dishwasher leaves spots after washing?
    • T
      tvaughanSep 5, 2025
      If your Asko Dishwasher leaves spots after washing, especially from lipstick or tea, use a detergent that contains a bleaching agent.
  • N
    nicole22Sep 7, 2025
    Why does my Asko Dishwasher control panel not react when pressed?
    • J
      Jennifer RodriguezSep 7, 2025
      If the control panel of your Asko Dishwasher isn't responding, it might be because you pressed it too soon after opening the door; wait a moment and try again. Check if the Child lock or Automatic child lock is activated. Also, ensure the control panel is clean; wipe it with a dry or slightly damp cloth.

Asko DBI344ID.W Specifications

General IconGeneral
BrandAsko
ModelDBI344ID.W
CategoryDishwasher
LanguageEnglish

Related product manuals