35
SERVICE MENUSERVICE MENU
SERVICE MENUSERVICE MENU
SERVICE MENU
Adjusting water intake
Press the program selector (S1) for 3 secs to
activate the menu for setting the water intake.
Then step through using the Program button
(S1).
Display shows: 0 Normal water intake volume
Display shows: 1 Water intake volume increases
by 5%
Display shows: 2 Water intake volume increases
by 10%
Display shows: 3 Water intake volume increases
by 15%
Display shows: 4 Time controlled water intake
Display shows: 5 Water intake volume increases
by 5 % time controlled
Display shows: 6 Water intake volume increases
by 10 % time controlled
Display shows: 7 Water intake volume increases
by 15 % time controlled
Confirm selection by pressing Start (S2). The
program returns to the main menu.
WW
WW
W
ater hardness settingater hardness setting
ater hardness settingater hardness setting
ater hardness setting
Activating setting menu:
1. Turn off the main power switch (1/0).
2. Wait at least 5 seconds.
3. Hold Start button (S2) pressed in
4. Switch on the main power switch (1/0).
5. Release Start button (S2)
6. Select the desired water hardness using
the Program button (S1), see the table below.
Setting: Water hardness [°dH]
The display shows: 0 0-5 (applies to
dishwashers with water softeners)
The display shows: 1 6-8
The display shows: 2 9-11
The display shows: 3 12-14
The display shows: 4 15-19
The display shows: 5 20-24
The display shows: 6 25-29
The display shows: 7 30-39
The display shows: 8 40-49
The display shows: 9 50+
Confirm selection by pressing Start (S2).
The program returns to the main menu.
To Next Page
Loading...
