Install in a closet
ASKO's front panel controls make it possible to
install the washers and dryers in a closet. Make
sure there is a ½” (12mm) minimum clearance
between units and cabinet or wall. To ensure
proper ventilation, we recommend louvered doors,
particularly for condenser dryers. Otherwise there
must be ventilation openings in the door. See
illustration for minimum ventilation openings:
Condensed water
Install the dryer so the condensed water will
continuously flow into a drain or sink. To do this,
follow the instructions below:
1. Connect the rubber hose supplied with the
dryer to the blue nipple.
2. Run the hose to a drain or sink, as illustrated.
NOTE!
The drain hose must not be more than 40” above
the floor.
25Customer Care Center
1-800-898-1879
www.askousa.com
Installation instructions
To Next Page
Loading...
