17
Troubleshooting
The machine will not start
Check
• that the door is properly closed.
• that the main power switch is on.
• that the Delayed Start option has not been
selected. To cancel Delayed Start, press the
Stop button for three seconds.
• that the plug is connected.
• that the main fuses have not blown.
The machine loses all power during a
program
Contact the service division.
Drying takes too long
• Check that the lint lter is not blocked. See
the Care and cleaning chapter.
• Empty the condensed water container. Clean
the evaporator lter (net lter + foam lter),
evaporator and lint lter, see chapter Care
and cleaning.
Error messages
If F10 ashes in the display, the condensed
water container is full. Empty the container and
restart the program.
If F29 ashes on the display the evaporator
lter needs cleaning. See the section Care and
cleaning.
If F30 is ashing on the display, the maximum
permitted program time has been reached.
To Next Page
Loading...
