asmodus Colossal 80W - System Updating; Firmware Update Process; Battery Handling Method; Battery Installation and Removal

05
6. System updating
1. The equipment enters updating mode “Download Mode”.
2. Connect the equipment to computer via USB cable.
3. Open the update software on computer and click “Connect” button. The grey block on
left of the button turns to green, indicating the equipment is successfully connected
with update software.
4. Click “File” button to select firmware to be updated (e.g.: xxx.firmware).
5. Click “Update” button to update.
6. After successful update, the equipment will prompt “Update OK”.
7. De-energize and restart.
☆ 7. Battery handling method ☆
1. The negative pole of the battery is against the negative pole of the machine。
2. Push the battery to the negative direction, and then remove the battery。
1. Warning when atomizer resistance is too high: “HIGH ATOMIZER”
2. Warning when atomizer resistance is too low: “LOW ATOMIZER”
3. Warning when atomizer resistance is removed: “ ATOMIZER REMOVE”
4. Warning when no atomizer is connected: “CHECK ATOMIZER”
5. Warning when atomizer gets short circuit: “ ATOMIZER SHORT”
6. Warning when battery voltage is too high: “HIGH BATTERY”
7. Warning when battery voltage is too low: “LOW BATTERY”
8. Warning when fire working time exceeds 10S: “WORK OVERTIME”
9. Display when device turns on: “ASMODUS”
10. Display when device turns off: “GX80HUT V2”
Tips: