Aspes AAC3000 - User Manual

44 pages

Save Page as PDF

To Next Page

Model:AAC3000

This appliance is intended for domestic use only.

Questions and Answers

S
Steven MacdonaldAug 9, 2025
Why is my Aspes AAC3000 not cooling properly?
- B
  Barbara TorresAug 9, 2025
  Several factors can cause poor cooling. It could be due to a power failure (wait for the power to be restored), the power switch being off (turn it on), a burned-out fuse (replace it), or dead remote control batteries (replace them). The unit's 3-minute protection might be activated (wait three minutes after restarting). Also, check if the temperature setting is higher than the room temperature (lower it), the heat exchanger is dirty (clean it), the air filter is dirty (remove and clean it), or the air inlet/outlet is blocked (turn off, remove obstruction, and turn back on). Ensure doors and windows are closed, and close curtains during high heat. Finally, low refrigerant might be the issue (check for leaks and top off).
K
Kristin MooreAug 25, 2025
What to do if Aspes AAC3000 heating is not working well?
- L
  Laura AndersonAug 26, 2025
  If your air conditioner isn't heating properly, consider these possible causes: there might be too much or too little refrigerant in the system (check for leaks and recharge), air or foreign material in the system (evacuate and recharge), a blocked system circuit (determine and replace the malfunctioning part), or a broken compressor (replace it). Also, check if the voltage is too high or low (install a manostat), the outdoor temperature is below 7°C (check for leaks and recharge), cold air is entering through openings (close all doors and windows), or there is low refrigerant (check for leaks and refill).