ASPION G-Log 2 – Quick guide
ASPION GmbH Abraham-Lincoln-Allee 12 76149 Karlsruhe, Germany
www.aspion.de +49 721 / 85149-128 support@aspion.de
Battery replacement
If the battery is empty, all data remains in the memory store, the sensor can no longer be
read out. To read out your data and to further use the sensor, replace the battery on a
clean, dry and non-conductive work surface:
▪ Unscrew the housing on the bottom side.
▪ Remove the battery using a blunt, non-metallic object (e.g. pencil).
▪ Avoid contact with electronic devices.
▪ Insert a new battery (recommended: Panasonic), type CR2032,
3 V/220 mAh into the holder, please mind the polarity.
▪ Wait 10 seconds before reading out the sensor. Check the battery capacity.
When exchanging the battery, the sensor keeps its previously set state and this state is also
adopted after the battery has been replaced. As soon as the battery is empty, the internal
timer also stops. Thus, please replace the battery quickly when a sensor is working. You can
reset the time after battery replacement by reactivating the sensor.
brief blinking of LEDs when
inserting the battery
Important to note
▪ You will find detailed explanations in the user manual.
▪ ASPION sensors are not designed for safety-relevant applications.
▪ Do not operate sensors which are visibly damaged.
▪ Do prevent penetration of fluids to prevent corrosion damage or a short circuit.
▪ Never use a sensor with leaking battery; avoid skin contact.
▪ The manufacturer does not assume any liability for damages which were caused due to
inappropriate use or wrong operation.
Never dispose of the sensor together with domestic waste. Send the sensors back
to the manufacturer or dispose of them properly as waste electrical equipment.
To Previous Page
Loading...
Need help?
General
