35
Screw the stainless steel sleeve from the Nautilus 2 clearomizer and
disconnect the glass tank from the device. Remove the old atomizer head
and insert a new one. Please rst drip a few drops of e-liquid directly into the
wick of the coil to make it fully saturated before rst use.
Connect the glass tank with the clearomizer and rell e-liquid. Screw the
stainless steel sleeve back to the clearomizers and sure that no e-liquid can
overow and / or leak.
Please note the following: Prior to rst use, drip a few drops of your e-liquid
on the atomizer head and let it sit before vaping. Please take several puffs
without activating the atomizer and leave the atomizer head sit for 15 minutes
in the e-liquid lled tank before use. Don’t clean atomizer heads with water.
Because atomizer coils are wearing parts, they must be changed regularly.
essuyez-la simplement à l‘aide d‘un chiffon sec. Dans la mesure où les têtes
sont des pièces consommables, elles doivent régulièrement être changées.
Press the re button ve times in quick succession (within 2 seconds) to turn
on the device and ve times to turn it off again. While the battery is locked,
press the re button for 3 seconds to shutdown the system. To turn it back
on again press the re button 5 times rapidly. We recommend that you turn
off your e-cigarette during transport and during long periods without use.
While holding the re button of the device, inhale the vapor slowly and
continuously through the mouthpiece of your e-cigarette. Release the re
button while exhaling the steam.
Changing the Atomizer Head
Power On/Off
Vaping
Using the Device
To Next Page
Loading...
