Circuit diagram
Machine operation instruction
1. Plug the power cord into the socket and switch on the power supply. Gently
press the power supply in the display area of the screen to enter the automatic
mode. When the machine is put on the working surface (bed sheet, quilt), UV,
ultrasonic display work, lift the machine out.
In normal operation, under the induction of dust mite intelligent sensor,
through the control of computer chip, the color band display of dust mite
quantity in the air intake echoes the work of the motor. When the air intake
sensor detects the increase of dust mite quantity in the air intake, the blue
light band display changes from left to right from blue to red (full red at
most), and the motor speed increases, the data display will also increase
synchronously (maximum 100). When the amount of dust mites in the wind
decreases, the blue display is increased synchronously, and the motor data
decreases
When the machine is working, press the switch again, the machine becomes full
speed, press the machine again to close
4
To Next Page
Loading...