31
2.10 Onboard Headers and Connectors
Onboard headers and connectors are NOT jumpers. Do NOT place
jumper caps over these headers and connectors. Placing jumper caps
over the headers and connectors will cause permanent damage of the
motherboard!
Serial ATA3 Connectors These two Serial ATA3
(SATA3_1: see p.12, No. 12)
(SATA3) connectors support
(SATA3_2: see p.12, No. 13)
SATA data cables for internal
storage devices. The current
SATA3 interface allows up to
6.0 Gb/s data transfer rate.
1
USB_PWR
P-8
GND
DUMMY
USB_PWR
P+8
GND
P-9
P+9
1
USB_P WR
P-10
GND
DUMMY
USB_P WR
P+10
GND
P-11
P+11
USB 2.0 Headers Besides four default USB 2.0
(9-pin USB6_7)
ports on the I/O panel, there
(see p.12 No. 26)
are three USB 2.0 headers on
this motherboard. Each USB 2.0
header can support two USB
2.0 ports.
(9-pin USB8_9)
(see p.12 No. 25)
(9-pin USB10_11)
(see p.12 No. 23)
Serial ATA2 Connectors These ve Serial ATA2
(SATA2_1: see p.12, No. 21)
(SATA2) connectors support
(SATA2_2: see p.12, No. 20)
SATA data cables for internal
(SATA2_3: see p.12, No. 17)
storage devices. The current
(SATA2_4: see p.12, No. 19)
SATA2 interface allows up to
(SATA2_5: see p.12, No. 18)
3.0 Gb/s data transfer rate.
SATA3_2
SATA3_1
SATA2_3 SATA2_5
SATA2_1 SATA2_2 SATA2_4
Serial ATA (SATA) Either end of the SATA data
Data Cable cable can be connected to the
(Optional)
SATA / SATAII / SATA3 hard
disk or the SATAII / SATA3
connector on this motherboard.
To Next Page
Loading...
