ASROCK B660-ITX - Page 49

44 45
English
ODT NOM (B1)
Use this to change ODT (CH B1) Auto/Manual settings. e default is [Auto].
ODT NOM (B2)
Use this to change ODT (CH B2) Auto/Manual settings. e default is [Auto].
ODT PARK (A1)
Congure the memory on die termination resistors' PARK for channel A1.
ODT PARK (A2)
Congure the memory on die termination resistors' PARK for channel A2.
ODT PARK (B1)
Congure the memory on die termination resistors' PARK for channel B1.
ODT PARK (B2)
Congure the memory on die termination resistors' PARK for channel B2.
Advanced Setting
ASRock Timing Optimization
Congure the fast path through the MRC.
ASRock Second Timing Optimization
Congure the second fast path through the MRC.
MRC Training Respond Time
Try Slowest MRC Training.
Realtime Memory Timing
Congure the realtime memory timings.
[Enabled] e system will allow performing realtime memory timing changes aer
MRC_DONE.
Reset for MRC Failed
Reset system aer MRC training is failed.
MRC Training on Warm Boot
When enabled, memory training will be executed when warm boot.