2525
2525
25
Chapter 3: BIOS SETUP UTILITYChapter 3: BIOS SETUP UTILITY
Chapter 3: BIOS SETUP UTILITYChapter 3: BIOS SETUP UTILITY
Chapter 3: BIOS SETUP UTILITY
3.1 Introduction3.1 Introduction
3.1 Introduction3.1 Introduction
3.1 Introduction
This section explains how to use the BIOS SETUP UTILITY to configure your system.
The SPI Memory on the motherboard stores the BIOS SETUP UTILITY. You may run the
BIOS SETUP UTILITY when you start up the computer. Please press <F2> during the
Power-On-Self-Test (POST) to enter the BIOS SETUP UTILITY, otherwise, POST will
continue with its test routines.
If you wish to enter the BIOS SETUP UTILITY after POST, restart the system by press-
ing <Ctl> + <Alt> + <Delete>, or by pressing the reset button on the system chassis.
You may also restart by turning the system off and then back on.
Because the BIOS software is constantly being updated, the follow-
ing BIOS setup screens and descriptions are for reference purpose
only, and they may not exactly match what you see on your screen.
3.1.13.1.1
3.1.13.1.1
3.1.1
BIOS Menu BarBIOS Menu Bar
BIOS Menu BarBIOS Menu Bar
BIOS Menu Bar
The top of the screen has a menu bar with the following selections:
Main To set up the system time/date information
Smart To load the BIOS according to your requirements
Advanced To set up the advanced BIOS features
H/W Monitor To display current hardware status
Boot To set up the default system device to locate and load the Op-
erating System
Security To set up the security features
Exit To exit the current screen or the BIOS SETUP UTILITY
Use < > key or < > key to choose among the selections on the menu bar,
and then press <Enter> to get into the sub screen.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
