ASROCK RIPTIDE Z790 PG - Page 46

English
42
Step 3
Before installing a M.2 SSD
module, please loosen the screws to
remove the M.2 heatsink.
*Please remove the protective lms
on the bottom side of the M.2
heatsink before you install a M.2
SSD module.
Step 4
Move the stando based on the
module type and length. Peel o the
yellow protective lm on the nut to
be used. Hand tighten the stando
into the desired nut location on the
motherboard.
Step 5
Align and gently insert the M.2 SSD
module into the M.2 slot. Please be
aware that the M.2 SSD module only
ts in one orientation.
1
1
2
A
A
20
o