ASROCK X570S PG Riptide - Page 41

English
35
X570S PG Riptide
1
underbolt AIC
Connector
(5-pin TB1)
(see p.8, No. 28)
Please connect a underbolt™
add-in card (AIC) to the
underbolt AIC connector via
the GPIO cable.
*Please install the underbolt™
AIC card to PCIE3 (default
slot).
*For the further information,
please visit www.asrock.com.
RGB LED Headers
(4-pin RGB_LED1)
(see p.8, No. 26)
(4-pin RGB_LED2)
(see p.8, No. 9)
ese two RGB headers are used
to connect RGB LED extension
cable which allows
users to choose from various LED
lighting eects.
Caution: Never install the RGB
LED cable in the wrong orienta-
tion; otherwise, the cable may
be damaged.
*Please refer to page 62 for
further instructions on these two
headers.
Addressable LED Headers
(3-pin ADDR _LED1)
(see p.8, No. 25)
(3-pin ADDR _LED2)
(see p.8, No. 8)
ese two Addressable headers
are used to connect Addressable
LED extension cable which
allows users to choose from
various LED lighting eects.
Caution: Never install the
Addressable LED cable in the
wrong orientation; otherwise,
the cable may be damaged.
*Please refer to page 63 for
further instructions on this
header.
+12V GRB
1
VOUT
DO_ADDR
GND
1