57
2.21 Driver Installation Guide
To install the drivers to your system, please insert the support CD to your optical
listed on the support CD driver page. Please follow the order from up to bottom side
to install those required drivers. Therefore, the drivers you install can work properly.
2.22 Installing Windows
®
7 / 7 64-bit / Vista
TM
/ Vista
TM
64-bit With
RAID Functions
If you want to install Windows
®
7 / 7 64-bit / Vista
TM
/ Vista
TM
64-bit OS on your SATA
/ SATA2 / SATA3 HDDs with RAID functions, please follow the steps below.
RAID mode is not supported under Windows
®
XP / XP 64-bit.
STEP 1: Set up UEFI.
B. Set the option “SATA Mode Selection” to [RAID] for SATA2_2 to SATA2_5 and
SATA3_0 and SATA3_1 ports.
Set the option “Marvell SATA3 M0 M1 Operation Mode” to [RAID] for SATA3_M0
and SATA3_M1 ports.
Set the option “Marvell SATA3 M2 M3 Operation Mode” to [RAID] for SATA3_M2
and SATA3_M3 ports.
which is located in the folder at the following path:
.. \ RAID Installation Guide
STEP 3: Install Windows
®
7 / 7 64-bit / Vista
TM
/ Vista
TM
64-bit OS on your
system.
After the installation of Windows
®
7 / 7 64-bit / Vista
TM
/ Vista
TM
64-bit OS, if you want to
manage RAID functions, you are allowed to use both “RAID Installation Guide” and “Intel
-
cated in the folder at the following path: .. \ RAID Installation Guide and the document in
the support CD, “Guide to Intel Rapid Storage”, which is located in the folder at the follow-
ing path: .. \ Intel Rapid Storage Information
If you want to use “Intel Rapid Storage” in Windows
®
environment, install
“SATAII driver” from the Support CD again so that “Intel Rapid Storage”
will be installed to your system as well.
To Next Page
Loading...
