Assa Abloy EMTEK LISCIO - Manual Programming; Manual Programming Commands

13
EN
If You WishTo Press Button Actions
Add a code # 1 and then # 3 Then enter new code and enter again to conrm (factory
setting is 4 digit mode)
Delete a code # 4 and then # 3 Then enter code to delete and enter again to conrm
Change master code # 3 and then # 3 again Then enter new master code and enter again to conrm
Turn ON Deny Users # 4 and then # 1
Turn OFF Deny Users # 5 and then # 1 (factory setting is OFF)
Deny Users can disable or enable all user codes – when ON, no user codes will work, only key operates lock
Delete all codes # 5 and then # 5 again
Set 4 digit code length # 5 and then # 2 (factory setting is 4 digits)
Set 6 digit code length # 5 and then # 3
Turn Beeper ON # 1 and then # 1 again (factory setting is ON)
Turn Beeper OFF # 1 and then # 2
Turn Extended timeout OFF # 2 and then # 1 (factory setting is OFF)
Turn Extended timeout ON # 2 and then # 2 again
Extended timeout mode allows for a longer duration of unlock time upon entry of a valid user code.
Turn Passage switch OFF # 3 and then # 1
Turn Passage switch ON # 3 and then # 2 (factory setting is ON)
Passage switch mode ON, choose between Passage (lock unsecured) and Privacy
(always locked) and OFF lock is always in Privacy (always locked).
Restore Factory Defaults enter # 1 and then # 4 enter master code to conrm
The lock can be programmed manually using the keypad buttons 1 through 5. This feature is made available but
programming using a smart phone is highly recommended.
Manual Programming Commands
To enter programming mode – press the #1 and the #5 buttons simultaneously
Enter the lock’s 6 digit master code (the master code will be on sticker on back cover page and inside trim plate of lock)
The features below now accessible by entering a combination of two buttons one after the other (not simultaneously)
Manual Programming
1
2
3
ENEN