Assa Abloy KP10G77 - User Manual

Installation Instructions For
Keypad 10 Line Lock KP10G77
A7113E
8/08
Copyright © 2005, 2007,2008, SARGENT Manufacturing, an ASSA ABLOY Group company. All rights reserved.
Reproduction in whole or in part without the express written permission of SARGENT Manufacturing is prohibited.

Assa Abloy KP10G77 Specifications

General

Brand	Assa Abloy
Model	KP10G77
Category	Keypad
Language	English

Summary

General Description

Specifications

Parts Breakdown

Features

Installation Instructions

Step #1 Verify Hand and Bevel of Door

Determining the correct door hand and bevel for installation.

Step #2 Door Preparation

Instructions for preparing the door, including template usage and hole requirements.

Step #3 Frame Preparation for Strike

Preparing the door frame for the strike plate installation.

Step #4 Latch and Fire Stop Plate Installation

Installing the latch bolt and fire stop plate with screws.

Step #5 Lock Installation

Procedure for installing the lock body into the door's cross-bore.

Step #6 Securing the Lock to Door

Attaching the inside rose assembly and securing the lock body.

Step #7 Installation of Outside Escutcheon

Routing keypad wires and installing the outside escutcheon.

Step #8 - Security of Outside Escutcheon

Securing the outside escutcheon using a specific screw.

Step #9 - Installation of Inside Escutcheon

Connecting wires and installing the inside escutcheon.

Step #10 Securing of Inside Escutcheon

Securing the inside escutcheon with screws and ferrule.

Step #11 Test Lockset

Testing the lockset functionality, including lever and keypad operation.

Step #12 - Battery Installation

Installing the batteries and securing the battery cover.

Programming Instructions

How to Change Cylinder (if required)

Procedure for replacing the lock cylinder and retainer.

To Begin Programming

Initial steps to start the programming sequence for the keypad lock.

Initial Set-Up Procedures

General guidelines and error handling for programming setup.

Change Master Code

Instructions for changing the existing Master Code.

To Enter the Emergency Code

Steps to program or change the Emergency Code.

To Enter the Supervisory Code

Procedure for programming or changing the Supervisory Code.

To Enter a User Code

Adding new standard user codes to the lock system.

To Enter a Passage (Maintained Mode) Code

Programming a code for passage (maintained) mode operation.

To Enter a One Time User Code

Programming a code that can only be used once.

To Deactivate “Beep” With the Depression of Each Key

Disabling audible feedback for key presses.

To Reactivate “Beep” With the Depression of Each Key

Re-enabling audible feedback for key presses.

To Clear the Entire Memory

Procedure to erase all stored codes and reset settings.

To Program Door Numbers into Keypad

Assigning specific door numbers to the keypad system.

Transaction Log

To Interrogate Transaction Log

Retrieving and viewing the recorded access events and transactions.

To Reset; Clear Transaction Log

Erasing all entries from the transaction log.

To Delete a User Number

Removing a specific user's access code from the system.

To Disable; Enable a User Number

Temporarily deactivating or reactivating a user's access.

To Set Unlock Time

Adjusting the duration the lock remains unlocked after valid entry.

Optional Equipment

Details on printers, auxiliary power units, and remote unlocking accessories.