Assa Abloy EMTEK User Manual

Installation Guide - Non-Keyed plates: Knob
IMPORTANT!: Knob location on the sideplate (Top, middle, bottom) varies depending on style.
Determine proper orientation BEFORE drilling holes.
IN4-NKEYPLTSKNB REV. 19A 11-22-19
2. Door Prep 1. Determine knob location & plate orientation
4. Mount Inside Trim Plate
Edge
Guide
Provided
Plates and knobs vary depending on style
6. Tighten Knob
Optional Thru Bolts
3. Install latch
BOTTOM MIDDLE TOP
2
1
4
"
2-3/8"
or
2-3/4"
1" Dia.
Edge Bores
2-1/8" Dia.
Bores
5. Mount Outside Trim Plate
Dummy plate
For Privacy function:
Threaded hole for the
privacy pin must face
the interior side of the
door.
Prior to drilling holes, align side plate
using Edge Guide (provided).
OutsideInside
Privacy Function
Make sure the release
hole lines up with the
privacy pin.
Thru bolts (provided)
may be used on hollow
doors instead of wood
screws (also provided).
After lock has been installed tighten
set screw with Allen Wrench.
Align Mounting
plate (sideplate not
shown for clarity)
2
1
Install Mounting Plate & Adjust for level
2
3
1
3
Install Sideplate

Assa Abloy EMTEK Specifications

General

Brand	Assa Abloy
Model	EMTEK
Category	Door locks
Language	English

Summary

Non-Keyed Knob Installation Steps

Determine Knob Location and Plate Orientation

Guides users to identify the correct knob and plate positioning before drilling commences.

Door Preparation

Details the necessary drilling for door preparation, including bore hole sizes for the lockset.

Install Latch

Explains the installation of the latch mechanism, emphasizing privacy function orientation.

Mount Inside Trim Plate

Instructs on mounting the interior side of the trim plate using an edge guide for alignment.

Mount Outside Trim Plate

Instructs on mounting the exterior side of the trim plate to the door.

Tighten Knob

Details the final step of tightening the knob securely using an Allen wrench.

Privacy Function and Optional Hardware

Privacy Function Details

Specifies the orientation for the privacy pin and release hole for privacy functions.

Optional Thru Bolts

Describes the use of optional thru bolts for installation on hollow doors.

Lever Installation Steps

Determine Lever Location and Plate Orientation

Guides users to identify the correct lever and plate positioning before drilling commences.

Door Preparation

Details the necessary drilling for door preparation, including bore hole sizes for the lockset.

Install Latch

Explains the installation of the latch mechanism, emphasizing privacy function orientation.

Mount Inside Trim Plate

Instructs on mounting the interior side of the trim plate using an edge guide for alignment.

Mount Outside Trim Plate

Instructs on mounting the exterior side of the trim plate to the door.

Tighten Lever

Details the final step of tightening the lever securely using an Allen wrench.

Privacy Function and Optional Hardware (Lever)

Privacy Function Details

Specifies the orientation for the privacy pin and release hole for privacy functions.

Optional Thru Bolts

Describes the use of optional thru bolts for installation on hollow doors.