Associated Electrics RC10 B74.2D TEAM KIT - Shock Assembly; Bag 11 Shock Assembly

17
:: :: Bag 11 -Bag 11 - Step 4 Step 4
:: :: Bag 11 -Bag 11 - Step 5 Step 5
:: :: Bag 11 -Bag 11 - Step 6 Step 6
Shock Fluids:
Front Shock: 30wt
Rear Shock: 30wt
Steps 9-10Step 8Steps 6-7Steps 4-5Steps 2-3
Shock Bleeding Steps:
1. Before assembly, get each bleed screw and
thread it 1-2 turns into the shock cap, then
remove the screw. This will make it easier
when you are bleeding your shocks.
2. Pull shock shaft down.
3. Fill shock body 3/4 full with silicone shock fl uid.
4. Slowly move the shock shaft up and down to
remove air from under the piston.
5. Wait for bubbles to come to surface.
6. Fill shock body to top with silicone shock fl uid.
7. Place a drop of oil in the cap and on cap
threads.
8. Install cap (without bleed screw) and tighten
completely.
9. Slowly compress shaft all the way to bleed
excess silicone shock fl uid out the hole in the
cap
(use rag around shock to catch excess fl uid).
10. Install M2x4mm button head screw until snug
while shaft is fully compressed.
Stroke
Front: 22mm
Rear: 28.5mm
Stroke
31510
2x4mm
BHCS
Build x2 front shocks
Build x4
Build x2 rear shocks
Shock fluid Shock fluid
Front: 22mm
Rear: 28.5mm
Stroke
Step 8
Steps 2-3
Steps 6-7
Steps 4-5
91926
13mm
Shock Cap
Stroke
91928
13mm
Threaded
Collar
91996
13mm
Threaded
Collar
O-ring
x4x4
x4x4
91943
13mm Front
Spring, Yellow
(3.80lb)
91950
13mm Rear
Spring, Blue
(2.20lb)
Racers Tip:
Use your fi nger to rub shock
fl uid on the O-ring for smoother
adjustment!
Front:
6mm
Rear:
6mm
91926
13mm Shock
Spring Cup
“Rear - 0mm”
91926
13mm Shock
Spring Cup
“Front - 9mm”
#91926 13mm Shock Spring Cups
0mm 5mm 9mm
Hold shock mounting
hardware intil after
anti-roll bar installation.
!