Need help?Do you have a question about the Associated Electrics RC10B6.1 and is the answer not in the manual?
General| Scale | 1/10 |
|---|---|
| Drive Type | 2WD |
| Suspension | Independent |
| Motor | Not Included |
| Differential | Ball Differential |
| Recommended Radio | 2-channel |
| Type | Buggy |
| Shock Type | Oil-filled |
| Body | Not included |
| Recommended Battery | 7.4V LiPo |
Lists key features of the RC10B6.1 competition buggy kit.
Lists necessary items for kit completion, such as radio and batteries.
Lists recommended tools and supplies for building and maintenance.
Visual guide to button and flat head screws with dimensions.
Visual guide to various ball bearings and ballstuds.
Visual guide to set screws, shims, and washers.
Visual guide to differential balls, nuts, and cap head screws.
Assembling the steering rack and related components.
Attaching the steering bellcrank and ballstuds.
Installing the front anti-roll bar and associated hardware.
Mounting the front bulkhead to the chassis.
Installing chassis weight and side rails.
Mounting the servo and connecting the steering link.
Assembling the front axle and steering blocks.
Installing caster blocks and ballstuds.
Installing caster hat bushing and hinge pin.
Installing the rear arms onto the chassis.
Installing arm mounts and the rear bumper.
Reference for arm mount setup combinations.
Preparing components for the gear differential.
Assembling the gear differential.
Installing gear differential gasket and outdrive.
Installing the laydown gearbox and top shaft.
Installing anti-roll bar and setting differential height.
Assembling the laydown gearbox top section.
Assembling the slipper clutch components.
Adjusting rear hub link settings for optimal geometry.
Installing CVA axles and wheel hexes.
Installing rear anti-roll bar and hinge pin.
Attaching ball cups to turnbuckles for suspension links.
Installing front camber turnbuckles for suspension adjustment.
Installing rear camber turnbuckles for suspension adjustment.
Assembling shock pistons and shafts.
Assembling shock bodies and eyelets.
Procedure for bleeding shocks to remove air.
Installing shock springs and spring cups.
Installing receiver and ESC into the chassis.
Installing the battery strap securely.
Discusses options for mounting the car's wing.
Instructions for gluing tires to wheels.
Instructions for preparing and painting the polycarbonate body.
Tips for new RC car tuners on making adjustments.
Optimizing motor gearing, mesh, and slipper clutch settings.
Adjusting differential height and selecting gearbox type.
Understanding caster, camber, and steering geometry.
Adjusting ride height, wheelbase, and roll resistance.
Provides contact details and website links for Team Associated.
To Next Page