Associated Electrics RC10T - Page 41

Put
the appropriate rings in
all
four front tires. Next
we
will install
the
shall
ow
outer wheel halves
in the narr
ow
front tires
and
the
deep
outer
wheel halves
in the wide front
tires.
Now
you will
need to
decide
which
of
the front tires
you intend to run. You
will then take the one set
of
inner
front
wheel halves
and
mount them to the tires that you
have chosen. When you
decide
to run the other set
of
tires,
you
will
need to remove the inner
wheel halves
and install
them on the other
wheel
s.
Make sure that the
wheels
and
tires are
evenly
seated before you tighten
down
the
wheel
screws. When you are
bolting
the wide front tires and
wheels
together
please
use the
l
onge
r 4/40
x 5/8" SHCS
and use the shorter
4-40 X
7/16" SHSC for the narrow
wheels
and tires.
I
7870
Fig.
152
Fig.
153
0
Fig.
154
Install the rear
wheel
on
the rear
axle.
You'
ll
pr
obably
have
to
turn the
wheel until
you seat the
groove in the
back
of the
wheel
over the
split
pin in the rear
axle.
When the
wheel is
correc
tl
y
seated,
insta
ll
and
tighten the
8/32"
ax
le l
ock
nut. Do both sides.
Fig.
154
0
Figs.
155
&
156
Pi
ck
o
ut
the
pa
ir
of
front
wheels
you're
go
ing to run. and
install
th
e four
#6906 ball
bearings in the
wheel
s.
Put
the
wheels
on the front
axles
and
install
the
4-40 locknuts. IMPORTANT:
MAKE SURE
THE
LOCKN
UTS
AREN'T
TOO TIGHT
AND
BINDING
THE
BEARINGS.
Fig.
155
pag
e 42