Associated RC10 - Chassis Assembly (Bag H); Electronics Installation (Bag I)

16
:: :: Chassis Build Chassis Build - Bag H - Bag H - Step 1- Step 1
4-40 x 3/8
BHCS
RC10
antenna
mount,
Clear
4-40 x 1/4
BHCS
RC10 nose
brace tubes
4-40 x 3/8
FHCS
6338
Antenna tube
and cap
:: :: Electronics Build - Electronics Build - Bag I Bag I - Step 1- Step 1
4-40 x 1/2
SHCS w/hole
RC10 battery
cup and strap
Clear
#4 aluminum
washer
x2x2
:: :: Electronics Build Electronics Build - - Bag I Bag I - Step 2- Step 2
Servo not
included!
Servo
horn and
screw not
included!
4-40 x 3/8
SHCS
89007
Servo horn
(recommended)
#4 aluminum
washer
RC10
servo mounts,
Clear
x4x4
x4x4
x2x2
Align Z-bend wires so
that the set screw
tightens down on
both wires at once!
!
1
2
Z bend
servo wire
1/8 set
collar
x2x2
x2x2
4-40 x 1/8
set screw
x2x2
Wires may need to be
bent slightly to clear
some servos, depending
on configuration!
!
Build left and right sides!