IB-2003 Series 40 Transfl ite - Stationary Conveyor
35
Set-up
Motor Rotation Decal
Motor rotation decal
4. After proper drive
rotation has been
determined retighten nuts to
original position.
5. Depending on installation or
how the conveyor will be
used, it may be necessary
to install an audible warning,
safety stop cord, or other
safety device. These
devices, if needed, should
be installed according to
applicable regulations and
codes.
Conveyor Support
Assembly
Conveyors may be shipped with
an assembled or unassembled
support structure. If the
support structure is shipped
unassembled, refer to the
assembly drawings and the
assembly mark numbering to
construct. See page 31 for
more information.
Cranes are recommended
for constructing support
structures.
Support structures may be bolt
down or weld down. Do not
tighten bolts or weld support
structure to foundation until
conveyor has been installed on
the supports. Use care when
lifting the conveyor onto the
support structure to prevent
damage.
To Next Page
Loading...
Need help?
General
