ASTEC 40 Series - Page 55

IB-2003
S
eries 40 Trans
fl
ite -
S
tationary
C
onveyor
56
Troubleshooting
Belt Cleaner
Noise or vibration 1. Incorrect tension.
1. Increase or decrease
tensioner setting.
2. Blade urethane may not
match application. Contact
factory for further assistance.
Problem
Symptom
Solution
Insuffi cient cleaning and
carryback
1. Incorrect tension.
2. Worn blade.
1. Increase or decrease
tensioner setting.
2. Inspect blade. Replace as
needed.
High blade wear rate 1. Too much tension. 1. Decrease tenioner setting.
Unusual wear or damage to
blade
1. Belt splice incorrect. 1. Inspect belt splice. Repair
as needed.