Astralpool ELITE 160 - User Manual

Questions and Answers

T
thomaskimAug 9, 2025
What to do if free chlorine levels are very low in my Astralpool ELITE 160 Swimming Pool Filter?
- T
  Tony WhiteAug 9, 2025
  If you find that the free chlorine levels in your pool water are very low when using your Astralpool Swimming Pool Filter, ensure the system is producing chlorine in the pool jets. Also, verify that the water chemical parameters (pH, combined chlorine, isocyanuric acid, etc.) are correct. You might also need to increase filtering time or add chlorine stabilizer (cyanuric acid) until a concentration of 25 – 30 g/m3 is achieved.
B
Briana WilliamsAug 15, 2025
Why does my Astralpool ELITE 160 Swimming Pool Filter's pH/ORP controller show extreme or unstable readings?
- J
  Joseph MeyerAug 15, 2025
  Unstable or extreme readings on your Astralpool Swimming Pool Filter's pH/ORP controller can stem from several causes: * A damaged pH/ORP sensor cable: Clean the contacts or replace the cable. * An air bubble in the sensor's membrane area: Hold the sensor vertically and gently shake it until the bubble rises. * A sensor fault: Replace the sensor. * The connection cable being too long or near electrical interference: Relocate the unit closer to the sensor.
A
areedAug 21, 2025
How to fix an Astralpool ELITE 160 Swimming Pool Filter production indicator always showing '0'?
- J
  Jason HarrisAug 21, 2025
  If the production indicator on your Astralpool Swimming Pool Filter consistently reads “0” at all production levels, check the electrodes, verify the connections between the power supply and the electrolysis cell, and check the salt concentration.
C
chapmanlisaAug 27, 2025
What to do if the power supply of my Astralpool Swimming Pool Filter is not turned on?
- C
  christopher67Aug 27, 2025
  If the power supply to your Astralpool Swimming Pool Filter isn't turning on, check that the system is properly connected to 230 V/50-60 Hz in the command box of the pump and inspect the fuse located on the bottom of the power supply.
A
Amber GraySep 2, 2025
Why is the pH/ORP sensor response slow on my Astralpool Swimming Pool Filter?
- C
  Christina WilliamsSep 2, 2025
  A slow response from the pH/ORP sensor on your Astralpool Swimming Pool Filter can occur if the sensor is electrostatically charged. During calibration, avoid drying the sensors with paper or cloth; clean them exclusively with water and shake lightly. It could also be due to insufficient renovation of the analyzed water. Ensure that the tip of the sensor is submerged in the water at the sample point, and that no air bubbles are present.