To Next PageTo Next Page
Need help?Do you have a question about the Astralpool Heliox UV MP 50 and is the answer not in the manual?
General| Brand | Astralpool |
|---|---|
| Model | Heliox UV MP 50 |
| Category | Lighting Equipment |
| Language | English |
Emphasizes the importance of reading the entire manual before installation and use.
Details grounding conductor sizes and connection requirements for safety.
Mandates connection to a circuit protected by a ground fault circuit interrupter.
Specifies the system is for pool end use only and not for other applications.
States that installation and handling must be done by qualified individuals.
Recommends checking electrical connectors for tightness to prevent overheating.
Instructs to install the control panel ensuring cooling grids are unobstructed.
Specifies the unit is designed for indoor use and not for outdoor applications.
Warns against removing the quartz sleeve lock nut during recirculation.
Warns against installing near corrosive chemicals like HCl.
Details grounding conductor connection to specific lugs on the UV chamber.
Ensures cooling fan and grids are not blocked for proper operation.
Equipment must be handled by truly qualified people.
Do not attempt to alter the system to operate at a different voltage.
Provides detailed wiring connections for the control panel for MP 50 to MP 300 models.
Connect lamp power and microswitch wires to the specified terminals.
Warns that lamp power shuts off automatically when the cover is removed.
Instructs to connect the ground wire to bonding lugs on the UV chamber.
Reiterate checking electrical connectors for tightness to prevent overheating.
Ensures filter is clean, pool is free of contaminants, and water parameters are optimal.
Advises on balancing pH and alkalinity for efficient UV treatment and lamp life.
Instructs to connect the system using the main switch on the control panel.
Never connect the system when the lamp is not inside the reactor.
Instructions for using the RUN key to switch on the UV lamp.
Instructions for using the STOP key to switch off the UV lamp.
Details the low flow condition, system response, and automatic reset upon restoration.
Details panel overheating, lamp disconnection, and cooling fan operation.
Ensures system components are disconnected from mains before maintenance.
Advises on safe handling of UV lamps, including cooling and glove usage.
Provides a step-by-step guide for removing and installing a new UV lamp.
