To Next PageTo Next Page
Need help?Do you have a question about the Astralpool Energy Sel 55 and is the answer not in the manual?
General| Power | 55W |
|---|---|
| Light Source | LED |
| Beam Angle | 120° |
| IP Rating | IP68 |
| Lifespan | 50, 000 hours |
Machine should not be used by persons with reduced physical, sensory, or mental abilities, or those lacking experience, without supervision.
Recommended salt concentration (4.0 g/l) and pH (7.0-7.4) for proper functioning.
Recommended TAC (12-18°F) and stabilizer (20-50 g/m³) levels for pool water.
Do not operate below 15°C; recommended chlorine concentration is 0.5-2.5 ppm.
Connection: 230V, 50/60Hz, 70W max. Must run with filtration pump.
Use 10-20 g/m³ stabilizer; too low doubles chlorine use, too high cancels effect.
Add salt to pool while filtration runs; wait for dissolution. Dosage: 4g/l.
Turn on, adjust to max production, run filtration 24/24 until 0.5 ppm chlorine.
Switch filtration to auto, check chlorine, adjust if needed. Electrode powers up after delay.
Test weekly; chlorine (0.5-2.5 ppm) and pH (7.0-7.4) are volatile.
Factory set to 4 hours; adjustable 1-99 hours based on water hardness (TH).
Never run below 3.5 g/l salt. Turn off below 15°C. Avoid max production unless needed.
De-scale with 80% water, 20% HCl solution. Check for high pH, low salt, long polarity change, or worn electrode.
Machine is in safety mode due to high current, voltage, or temperature.
Check salt concentration, water temperature, and electrode condition (clean, no scale).
