Astralpool Energy Sel Series

Need help?

Do you have a question about the Astralpool Energy Sel Series and is the answer not in the manual?

Summary

IMPORTANT

3 - Electrical connections

B - Unit power supply

C - Salt electrode power supply

4 - Commissioning

4.2 - Salt

Instructions for adding salt to the pool and checking concentration.

4.3 - Switching on

Steps for turning on the chlorinator and setting initial parameters.

5 - Flow switch

NEVER INSTALL THE DETECTOR ON DOWNWARD FLOW

Crucial warning against installing the flow detector in downward flow piping.

7 - Tips for proper use

7.2 - Chlorine and pH testing methods

Methods for testing chlorine and pH levels in pool water.

7.3 - Shock (breakpoint) chlorination

7.5 - Adjusting the reverse polarity time

How to adjust the frequency of electrode polarity reversal.

7.7 - Verification and maintenance

Procedures for checking and maintaining the chlorinator and its components.

Error signals

Adding salt

Detailed instructions for adding salt, including a calculation formula.

Winterization

Tips for proper use of the electrode

Advice on maximizing the lifespan and performance of the electrode.

Scale-covered or furred-up electrode

9 - What to do in case of problem?

Problem: The chlorinator stays off.

Troubleshooting steps when the chlorinator does not turn on.

Problem: The light stays on, but prod 1 and prod 2 are off.

Diagnosing safety mode issues where the unit is powered but not producing.

Problem: The machine does not reach the electric current set-point

Troubleshooting low current issues, checking salt, temperature, and electrode condition.

Problem: Low chlorination in spite of the proper running of the chlorinator

Addressing low chlorine output despite the unit operating correctly.

Problem: No chlorine although the chlorinator is running

Identifying causes for zero chlorine output, like hydrogen peroxide or imbalanced water.