• Turn the rotary dial to the " setting. The
screen will display "I" indicating that the
measurement function is square wave output
• Connect the test leads in parallel to both ends of the tested
power supply or circuit.
• After the reading stabilizes, record the reading from the
LCD screen
• Turn the rotary switch to the OFF position to turn off the
Meter.
MAINTENANCE
CLEANING THE METER:
If there is dust or humidity in the terminals, it may produce erroneous
measurements. Please clean the Meter as follows:
• Turn off the power to the Meter and remove the test leads.
• Turn the meter over and shake out the dust accumulated in
the input jack, wipe the case with a damp cloth or mild
detergent. Wipe the contacts in each terminal with a clean
cotton swab dampened in alcohol.
SPECIFICATIONS
Digital Display
Sampling Speed
LCD Dimensions
Range Selection
Polarity Indication
2000, 31/2
2 Times/Second
49 x 17mm
Manual
" " Automatically Displayed
-20
To Next Page
Loading...
