• Before using the meter, please check whether there are cracks or
damage to the plastic parts of the meter casing. Do not use the Meter if
all or part of the exterior casing is damaged
• Before using the Meter, please check whether the test leads are
cracked or damaged. Please replace the test leads with those of
the same model and same electrical specifications if the leads
are damaged
• Use the Meter according to the measurement category, voltage or
current rating specified on the meter or manual
• Comply with local and national safety regulations.Wear personal
protective equipment (such as approved rubber gloves, masks, and
flame-retardant clothing, etc.) to prevent injury from electric shocks and
arcs when hazardous liveconductors are exposed
• Replace the battery as soon as the low-battery indicator appears to
avoid measurement errors.
• Do not use the Meter around explosive gas, steam or humidenviron
ments
• When using the test leads, keep your fingers behind the finger guards.
• When measuring, connect the neutralwire or ground wire first, then
connect the live wire; when disconnecting,disconnect the livewire first,
and then disconnect the neutral and ground wires.
• Before opening the case or battery cover, removethe test leads from
the Meter first. Do not use the Meter when it is disassembled or when
the battery cover is opened
• The Meter can only be used with the equipped test leads to meet the
requirementsof safety standards. If the test leads are damaged and
need to be replaced, replace only with the same model and the same
electrica specifications.
-4
To Next Page
Loading...
