• Do not apply more than the rated voltage, as marked on the
Meter, between the terminals or between any terminal and
grounding.
• When the Meter is working at an effective voltage over 60V
in DC or 30V rms in AC, special care should be taken
because there is a danger of electric shock.
• Use the proper terminals, function, and range for your
measurements.
• When using the test leads, keep your fingers behind the
finger guards.
• Disconnect circuit power and discharge all high-voltage
capacitors before testing resistance, continuity, and diodes.
• Remove the connection between the testing leads and the
circuit being tested. Turn the Meter power off before opening
the Meter case.
• When servicing the Meter, use only the same model number
or identical electrical specifications replacement parts.
• The internal circuit of the Meter shall not be altered to avoid
damage of the Meter and any accident.
• Clean using a soft cloth and mild detergent for the surface of
the Meter. Do not use abrasive materials or solvents to
prevent the surface of the Meter from corrosion and
damage.
• Turn the Meter off when not in use and take out the battery
when it is not going to be used for an extended period of
time. Regularly check the battery as it may leak when it has
not been used for some time.
• Replace the battery as soon as leaking appears. A leaking
battery will damage the Meter.
• Do not move the multimeter while measuring to avoid
inaccurate readings.
-3
To Next Page
Loading...
