Note that MOON mode is enabled by default, adding one extra mode (mode 0) to the above.
Pre-programmed strobes (disabled by default):
Additional UI settings are available to control the button back-light. While in the battery check mode,
press&hold the button. A double flash followed by a single blink is again the prompt for the first
setting:
Specifications
Emitter: one LED, cool white or neutral white , mounted on copper DTP MCPCB
Flux: 2400 lumen
Intensity: 190,000cd
Range: 875 meters
Firmware: Tom E’s open-source GPL NarsilM v1.3 adapted by Texas_Ace
User interface:
By default the FT03 is set to use the very intuitive Narsil smooth RAMPING UI. Instant
access to a TURBO mode is also provided.
A more conventional discrete level MODE-SET UI is available as an alternative. Any one of 12
predefined mode-sets can be selected.
MOMENTARY mode is useful for signaling purposes or rapidly/briefly lighting up targets.
Battery: One 26650 cell (or a 21700/18650 cell) Cells are not included.
Driver: Texas Avenger FET Driver with charging
Reflector: High quality smooth reflector
Lens: Glass with anti-reflective coating
To Next Page
Loading...