EZ Backup
To start EZ Backup conguration:
1. Click
EZ Backup from the main screen.
2. Check if the SATA cables
and power cords are installed
properly. Click Next to
continue.
3. Click
Next to continue the
conguration.
4. Before proceeding, ensure that
you have back up all original
data in the hard disk connected
to the SATA_E2 (white, port 1)
connector on the motherboard.
Otherwise, the system erases
all data in the port 1 hard disk.
Click Next to continue.
5. The setup is completed. Click
OK to close the conguration
window.
To Next Page
Loading...
