Asus BE24ECSBT - Page 12

4. Assemble the LVDS
Cable/Main Board to
Panel wire to the
Main Board & Panel.
5. Assemble Lamp wire
to Panel.
4
1. Insert Sensor cable
to Main Board and
paste 1 Foil-tape.
2. Assemble Rear
Case to monitor
and lock 4 screws.
Screw:
(#SCRW
FPHM4*10L(7.7/1.6)B-
ZNNY)
Screw
drive
Torque :
8~10 Kg-
cm
Don’t paste the wire on the screw
Don’t cross the cable
The wire can’t cover on
the screw
Fix the wire in the
wire clip
This wire clip don’t
fix the wire
Paste on Panel
Paste under the shielding
Paste under the Panel below side
Do not paste the wire on this side