ASUS CUSL2 User’s Manual 47
4. BIOS SETUP
4. BIOS SETUP
6. When prompted to confirm the BIOS update, press Y to start the update.
Updating BIOS
NOTE: When you see the message “Boot Block is different”, you may
still press <Y> to update the BIOS. Yet if the update fails, your system
will run a greater risk of boot failure depending on whether the boot
block is damaged or not.
7. The utility starts to program the new BIOS information into the flash
ROM. The boot block will be updated automatically only when neces-
sary. This will minimize the chance that a failed update will prevent
your system from booting up. When the programming is finished, Flashed
Successfully will be displayed.
To Next Page
Loading...
Need help?
General
