Asus H110M-C - 1.7 Connectors

ASUS H110M-C
1-11
1.7 Connectors
1.7.1 Rear panel connectors
5 64
78
1
11
9
32
10
1. PS/2 mouse port (green).ThisportisforaPS/2mouse.
2. Serial port.This9-pinCOMportisforpointingdevicesorotherserialdevices.
3. Video Graphics Adapter (VGA) port.This15-pinportisforaVGAmonitororother
VGA-compatibledevices.
4. LAN (RJ-45) port.ThisportallowsGigabitconnectiontoaLocalAreaNetwork(LAN)
through a network hub.
2. Chassis intrusion header (4-1 pin CHASSIS)
This header is for a chassis-mounted intrusion detection sensor or switch. Connect one
end of the chassis intrusion sensor or switch cable to this header. The chassis intrusion
sensororswitchsendsahigh-levelsignaltothisheaderwhenachassiscomponentis
removedorreplaced.Thesignalisthengeneratedasachassisintrusionevent.
Bydefault,thepinlabeled“ChassisSignal”and“Ground”areshortedwithajumper
cap.Removethejumpercapsonlywhenyouintendtousethechassisintrusion
detection feature.
H110M-C
H110M-C Chassis intrusion connector
+5VSB_MB Chassis Signal GND
CHASSIS