Asus H170M-E D3 - Advanced Menu - USB and Devices; USB Configuration

SMART Self Test [On]
S.M.A.R.T. (Self-Monitoring, Analysis and Reporting Technology) is a monitoring system that
shows a warning message during POST (Power-on Self Test) when an error occurs in the
hard disks. Conguration options: [On] [Off]
SATA6G_3~6(Gray) [Enabled]
Allow you to enable/disable the SATA6G_3~6 port. Conguration options: [Disabled]
[Enabled]
Hot Plug [Disabled]
These items allow you to enable/disable SATA Hot Plug Support. Conguration options:
[Disabled] [Enabled]
The following item appears only when you set the Hot Plug item to [Enabled].
Mechanical Presence Switch [Enabled]
Enables or disables reporting if the SATA port has an Mechanical Presence Switch.
Conguration options: [Disabled] [Enabled]
2.6.7 USB Conguration
The items in this menu allow you to change the USB-related features.
The USB Devices item shows the auto-detected values. If no USB device is detected, the
item shows None.
Legacy USB Support [Enabled]
[Enabled] Your system supports the USB devices in legacy operating systems.
[Disabled] Your USB devices can be used for BIOS setup only and cannot be
recognized in the boot devices list.
[Auto] Your system automatically detects the presence of USB devices at startup.
If any USB devices are detected, the legacy USB support is enabled.
XHCI Hand-off [Disabled]
[Enabled] Enables the support for operating systems without an XHCI hand-off
feature.
[Disabled] Disables the XHCI Hand-off support.
USB Single Port Control
The subitems in this menu allow you to set the USB Port Disable Override features.
USB3_1/2/3/4/5/6/7/8, USB9/10/11/12/13/14 USB Port [Enabled]
Allows you to enable or disable the USB ports individually. Conguration options:
[Disabled] [Enabled]
Refer to section 1.2.3 Motherboard layout for the location of the USB ports.
ASUS H170M-E D3 2-31