Asus M2N 1394 - IDE Configuration; Primary IDE Master;Slave

ASUS M2N 1394 2-15
2.3.4 IDE Conguration
The items in this menu allow you to set or change the congurations for the IDE
devices installed in the system. Select an item then press <Enter> if you wish to
congure the item.
IDE Conguration
Onboard IDE Controller [Enabled]
OnChip S-ATA Controller [Enabled]
SATA Mode Select [IDE Mode]
Onboard IDE Controller [Enabled]
Allows you to enable or disable the onboard IDE controller.
Conguration options: [Enabled] [Disabled]
OnChip S-ATA Controller [Enabled]
Allows you to enable or disable the OnChip SATA.
Conguration options: [Disabled] [Enabled]
SATA Mode Select [IDE Mode]
Conguration options: [IDE Mode] [RAID Mode] [AHCI Mode]
2.3.5 Primary IDE Master/Slave
While entering Setup, the BIOS automatically detects the presence of IDE devices.
There is a separate sub-menu for each IDE device. Select a device item then
press <Enter> to display the IDE device information.
Third IDE Master
Device : Not Detected
Type [Auto]
LBA/Large Mode [Auto]
Block(Multi-sector Transfer) M [Auto]
PIO Mode [Auto]
DMA Mode [Auto]
SMART Monitoring [Auto]
32Bit Data Transfer [Enabled]