Asus M2V-MX SE - IDE Connectors

ASUS M2V-MX SE 1-25
2. IDE connectors (40-1 pin PRI_IDE, SEC_IDE)
The onboard IDE connectors are for Ultra DMA 133/100/66 signal cable(s).
There are three connectors on each Ultra DMA 133/100/66 signal cable:
blue, black, and gray. Connect the blue connector to the motherboard’s IDE
connector, then select one of the following modes to congure your device(s).
• Pin 20 on the IDE connector is removed to match the covered hole on the
Ultra DMA cable connector. This prevents incorrect insertion when you
connect the IDE cable.
• Use the 80-conductor IDE cable for Ultra DMA 133/100/66 IDE devices.
If any device jumper is set as “Cable-Select,” make sure all other device
jumpers have the same setting.
M2V-MX SE
R
M2V-MX SE IDE Connectors
SEC_IDE
NOTE: Orient the gray markings
(usually zigzag) on the ID
ribbon cable to PIN 1.
PRI_IDE
PIN1
Blue or black
Drive jumper Mode Cable
setting of device(s) connector
Single device Cable-Select or Master - Blue
Two devices Cable-Select Master Blue
Slave Black
Master Master
Slave Slave