2-24 Chapter 2: BIOS Setup
TRCD [Auto]
Conguration options: [Auto] [3 CLK] [4 CLK] [5 CLK] [6 CLK]
TRP [Auto]
Conguration options: [Auto] [3 CLK] [4 CLK] [5 CLK] [6 CLK]
TRAS [Auto]
Conguration options: [Auto] [5 CLK] [6 CLK] ... [18 CLK]
Command Timing 2T Mode [Auto]
Sets the 2T mode. Conguration options: [Auto] [1T] [2T]
MCT Timing Mode [Auto]
Sets the MCT Timing mode.
Conguration options: [Auto] [Manual]
The following item appears when the MCT Time Mode item is set to [Manual].
TRRD [Auto]
Conguration options: [Auto] [2T] [3T] [4T] [5T]
TRC [Auto]
Conguration options: [Auto] [11T] [12T] ... [25T]
Bank Int erlea cving [A uto]
Sets whether to allow memory accesses to be spread out over BANKS
on the same node or across nodes, decreasing access contention.
Conguration options: [Disabled] [Auto]
Enable Clock to All DIMMs [Disabled]
Allows you to enable or disable clock to all DIMMs.
Conguration options: [Disabled] [Enabled]
MemClk Tristate C3/ATLVID [Disabled]
Allows you to enable or disable the MemCLK Tri-Stating During C3 and Alt
VID. Conguration options: [Disabled] [Enabled]
Memory Hole Remapping [Disabled]
Allows you to enable or disable Memory Remapping around the memory
hole. Conguration options: [Disabled] [Enabled]