Asus M3A - Motherboard - ATX - Ai Net 2

4-20 Chapter 4: BIOS setup
2T Mode [Auto]
Allows selection of the 2T Mode.
Conguration options: [Auto] [Disabled] [Enabled]
DRAM Timing Mode [Auto]
Allows selection of the DRAM Timing Mode.
Conguration options: [Auto] [DCT 0]
The following sub-items appear only when you set the DRAM Timing Mode
item to [DCT 0].
CAS Latency (CL) [Auto]
Conguration options: [Auto] [3 CLK] [4 CLK] [5 CLK] [6 CLK] [7 CLK
DH_Only]
TRCD [Auto]
Conguration options: [Auto] [3 CLK] [4 CLK] [5 CLK] [6 CLK]
TRP [Auto]
[Auto] [3 CLK] [4 CLK] [5 CLK] [6 CLK]
TRAS [Auto]
Conguration options: [Auto] [5 CLK] [6 CLK] ~ [17 CLK] [18 CLK]
Atheros POST Check LAN cable [Disabled]
Allows you to enable or disable LAN cable check during POST. When enabled, the
menu reports the cable faults or shorts, and displays the point (length) where the
faults or shorts are detected. Conguration options: [Disabled] [Enabled]
4.4.2 AI NET 2
This menu displays the status of the Local Area Network (LAN) cable connected to
the LAN (RJ-45) port.
Select Screen
Select Item
+- Change Option
F1 General Help
F10 Save and Exit
ESC Exit
v02.61 (C)Copyright 1985-2007, American Megatrends, Inc.
BIOS SETUP UTILITY
Tools
AI NET 2
Pair Status Length
1-2N/A Atheros Controller 0
3-6N/A
4-5N/A
7-8N/A
Atheros POST Check LAN cable [Disabled]
Atheros Check LAN
cable during POST.