Asus M4A77T/USB3 - HW Monitor Configuration; Anti Surge Support

ASUS M4A77T/USB3 2-17
Power on By PS/2 Keyboard [Disabled]
Enables or disables PS/2 Keyboard to generate a wake event.
Conguration options: [Disabled] [Ctrl + Esc to Wake up] [Ctrl + F1 to Wake up] [Ctrl + Space
to Wake up]
Power on From S5 By RTC Alarm [Disabled]
Enables or disables RTC to generate a wake event. Conguration options: [Disabled]
[Enabled]
2.5.5 HW Monitor Conguration
CPU / MB Temperature [xxxºC/xxxºF] or [Ignored]
The onboard hardware monitor automatically detects and displays the motherboard and CPU
temperatures. Select [Ignored] if you do not want the detected temperatures to be displayed.
CPU / Chassis Fan Speed [xxxxRPM] or [Ignored]
The onboard hardware monitor automatically detects and displays the CPU / Chassis fan
speeds in rotations per minute (RPM). If the fan is not connected to the motherboard, the eld
shows N/A. Select [Ignored] if you do not wish to display the detected speed.
CPU Q-Fan Control [Enabled]
Allows you to enable or disable the CPU Q-Fan function. Conguration options: [Disabled]
[Enabled]
CPU Fan Speed Low Limit [200]
This item appears only when you enable the CPU Q-Fan Control feature and allows you
to set the low limit of the CPU fan speed over which a warning message will show up.
Conguration options: [500 RPM] [400] [300] [200] [1.00%] [Ignored]
CPU Fan Prole [Standard]
This item appears only when you enable the CPU Q-Fan Function feature and allows you to
set the appropriate performance level of the CPU fan.
[Standard] Sets to [Standard] to make the CPU fan automatically adjust depending on
the CPU temperature.
[Silent Mode] Sets to [Silent Mode] to minimize the fan speed for quiet CPU fan operation.
[Turbo] Set to [Turbo] to achieve maximum CPU fan speed.
[Manual] Allows you to individually set the CPU fan parameters.
VCORE Voltage, 3.3V Voltage, 5V Voltage, 12V Voltage [xx.xxxV] or [Ignored]
The onboard hardware monitor automatically detects the voltage output through the onboard
voltage regulators. Select [Ignored] if you do not want the detected voltage to be displayed.
2.5.6 Anti Surge Support [Enabled]
Allows you to enable or disable the Anti-Surge protection feature. Conguration options:
[Disabled] [Enabled]