ASUS M4A78LT-M LX 2-11
VDDNB Over Voltage [Auto]
Sets the VDDNB over voltage. The valid value ranges vary depending on your CPU model.
Use <+> / <-> keys to adjust the ratio. Conguration options: [Auto]
LoadLine Calibration [Auto]
Sets the LoadLine. Conguration options: [Auto] [0%] [3.225%] [6.450%] [9.675%] [12.90%]
[16.125%] [19.35%] [22.575%] [25.8%] [29.025%] [32.25%] [35.475%] [38.7%] [41.925%]
[45.15%] [48.375%] [51.6%] [54.825%] [58.05%] [61.275%] [64.5%] [67.725%] [70.95%]
[74.175%] [77.4%] [80.625%] [83.85%] [87.075%] [90.3%] [93.525%] [96.75%] [100%]
If the system becomes unstable after changing the setting, set it back to [Auto] for safe
mode.
HT Link Frequency [Auto]
Sets the HyperTransport link speed. Conguration options: [Auto] [200MHz] [400MHz]
[600MHz] [800MHZ] [1000MHz] [1200MHz] [1400MHz] [1600MHz] [1800MHz] [2000MHz]
HT Link Width [Auto]
Sets the HyperTransport link width. Conguration options: [Auto] [8 Bit] [16 Bit]
HT Over Voltage [Auto]
Sets the HT over voltage. The values range from 1.20000V to 1.38000V with a 0.01500V
increment. Use the <+> / <-> keys to adjust the value. Conguration options: [Auto]
[Max. = 1.38000V] [Min. = 1.20000V]
Memory Clock Mode [Auto]
Sets the memory clock mode. Conguration options: [Auto] [Manual]
DRAM Timing Mode [Auto]
Sets the DRAM timing mode. Conguration options: [Auto] [DCT 0] [DCT 1] [Both]
Memory Over Voltage [Auto]
Sets the memory over voltage. The values range from 1.3500V to 2.2050V with a 0.0150V
increment. Use the <+> / <-> keys to adjust the value. Conguration options: [Auto] [Max. =
2.2050V] [Min. = 1.3500V]
Chipset Over Voltage [Auto]
Sets the chipset over voltage. The values range from 1.10000V to 1.61000V with a 0.01500V
increment. Use the <+> / <-> keys to adjust the value. Conguration options: [Auto]
[Max. = 1.61000V] [Min. = 1.10000V]
PCI/PCIe CLK Status [Enabled]
Enables or disables clock for PCI/PCIe slot. Conguration options: [Disabled] [Enabled]
The following item only appears when you set Memory Clock Mode to [Manual].
Memclock Value [400MHz]
Selects the DRAM frequency programming method.
Conguration options: [400MHz] [533MHz] [667MHz] [800MHz]